Artiza LTE eNB Test Solutions

RRC Protocol

According to 3GPP TS 36.331, the RRC protocol includes the following main functions:
  • Broadcast of system information:
    • Including NAS common information
    • Information applicable for UEs in RRC_IDLE, e.g., cell (re-)selection parameters, neighboring cell information and information (also) applicable for UEs in RRC_CONNECTED, e.g., common channel configuration information.
    • Including ETWS notification
  • RRC connection control:
    • Paging
    • Establishment/modification/release of RRC connection, including e.g., assignment/ modification of UE identity (C-RNTI), establishment/ modification/ release of SRB1 and SRB2, access class barring
    • Initial security activation, i.e., initial configuration of AS integrity protection (SRBs) and AS ciphering (SRBs, DRBs)
    • RRC connection mobility including e.g., intra-frequency and inter-frequency handover, associated security handling, i.e., key/ algorithm change, specification of RRC context information transferred between network nodes
    • Establishment/ modification/ release of RBs carrying user data (DRBs)
    • Radio configuration control including e.g., assignment/ modification of ARQ configuration, HARQ configuration, DRX configuration
    • QoS control including assignment/ modification of semi-persistent scheduling (SPS) configuration information for DL and UL, assignment/ modification of parameters for UL rate control in the UE, i.e., allocation of a priority and a prioritized bit rate (PBR) for each RB
    • Recovery from radio link failure
  • Inter-RAT mobility including e.g., security activation, transfer of RRC context information
  • Measurement configuration and reporting:
    • Establishment/ modification/ release of measurements (e.g., intra-frequency, inter-frequency and inter- RAT measurements)
    • Setup and release of measurement gaps
    • Measurement reporting
    • Other functions including e.g., transfer of dedicated NAS information and non-3GPP dedicated information, transfer of UE radio access capability information, support for E-UTRAN sharing (multiple PLMN identities)
    • Generic protocol error handling
    • Support of self-configuration and self-optimization

NOTE: Random access is specified entirely in the MAC including initial transmission power estimation.

Figure 20 : RRC States (from 3GPP TS 36.331)

Figure 20 : RRC States (from 3GPP TS 36.331)

Signaling Radio Bearers (SRB) are defined as Radio bearers that are used only to transmit RRC and NAS messages. SRB’s are classified into

Signaling Radio Bearer 0: SRB0: RRC message using CCCH logical channel.
Signaling Radio Bearer 1: SRB1: is for transmitting NAS messages over DCCH logical channel.
Signaling Radio Bearer 2: SRB2: is for high priority RRC messages. Transmitted over DCCH logical channel.